Mobile Automation from Sontheim

Mobile Automation

System solutions for mobile machines

Industrial Automation from Sontheim

Industrial Automation

System solutions for industry 4.0

Diagnostics from Sontheim

Diagnostics

System solutions based on standards

Connectivity from Sontheim

Connectivity

System solutions for IoT

  • Search
Search words under length of 4 characters are not processed.
2000 results:
981. PROFINET  
Due to the modularity of the network, the user can choose the mode of operation himself. The advantage of the fieldbus is its flexibility through scalable real-time. In addition to real-time…  
982. PROFINET  
As a PROFIBUS extension, the Ethernet-based PROFINET fieldbus is manu­facturer-inde­pendent and an open standard of the PROFIBUS & PROFINET International Organ­ization (PI).…  
983. PROFIBUS  
The master, usually only one in the system, sends data as an active participant according to its cycle. In addition, it requests data from passive participants, the so-called slaves,…  
984. PROFIBUS  
PROFIBUS is a fieldbus communication standard in the automation technology. The universal fieldbus is mainly used in manu­facturing-, process- and building auto­mation and has been…  
985. Ethernet  
Due to the wired data network technology, communication takes place via the protocol of all devices connected in the network – even over long dis­tances. The advantages of the stan­dard are…  
986. Ethernet  
The aim of the development of Ethernet was the fast and local networking of software and/or hardware without delays and with low error rates. The most important specification is the IEE standard…  
987. K-Line – ISO 9141 - Application  
Application One application example is the on-board diagnosis of control units. The K-Line was already integrated as a standard in the first OBD standard and has been supported ever since. The…  
988. K-Line – ISO 9141  
This means that the sending and receiving of messages does not happen at the same time, since both terminals operate on the same channel. If an L-line is used in addition to the K-line, data…  
989. K-Line – ISO 9141  
The bidirectional one-wire bus is one of the first ways to access to control devices. The entire com­mu­ni­cation runs over only one wire and is used for data trans­mission…  
990. LIN-Bus  
The table defines which subscriber should send the data part of the message of up to eight bytes in size. It also describes what the data is and which subscriber should read the message. Each slave…  
Search results 981 until 990 of 2000