Due to the wired data network technology, communication takes place via the protocol of all devices connected in the network – even over long distances. The advantages of the standard are…
The aim of the development of Ethernet was the fast and local networking of software and/or hardware without delays and with low error rates. The most important specification is the IEE standard…
Application
One application example is the on-board diagnosis of control units. The K-Line was already integrated as a standard in the first OBD standard and has been supported ever since. The…
This means that the sending and receiving of messages does not happen at the same time, since both terminals operate on the same channel. If an L-line is used in addition to the K-line, data…
The bidirectional one-wire bus is one of the first ways to access to control devices. The entire communication runs over only one wire and is used for data transmission…
The table defines which subscriber should send the data part of the message of up to eight bytes in size. It also describes what the data is and which subscriber should read the message. Each slave…
A LIN consists of a master and one or more slaves. The number of slaves is normally limited to 16. A master is typically a microcontroller that connects the local interconnect network to…
The serial communication system is very cost effective to connect sensors and actuators in vehicle networks as subsystem to existing bus systems. LIN is mainly used where the bandwidth of…
The Local Interconnect Network (LIN) bus system was developed by the LIN consortium until 2010. It comprises the physical layer, the bus protocol, the interface to the…
Cyclic transmission of IO data Acyclic transmission of required data (parameters, diagnostics, device identification, …) Clock synchronization Comfortable system diagnostics
…
